A clear sequence from site assessment to operational verification.
1. Capture the opportunity
Review the existing array, energy usage and performance goals without promising a universal yield increase.
2. Inspect the premises
Document access, panels, rails, roof anchors, cable movement allowances and environmental exposure.
3. Identify parts and loads
Determine materials, steel sections, moving mass, motor requirements, travel limits and wind loads.
4. Prepare the plan
Prepare mechanical drawings, sensor and actuator architecture, commissioning criteria and safety provisions.
5. Install
Carry out the approved retrofit with qualified installers and appropriate structural and electrical review.
6. Test and commission
Verify the defined motions, operating limits, manual control, faults and resulting system performance.
Educational information only. The suitability and safety of a retrofit depend on a site-specific engineering review.